Yeah, so, it's been a while since I was here. Sorry about that. It's not that I haven't been busy creating things, just that I tend to use Instagram more nowadays than the blog. However, I think I shall have a shot at getting back into the swing of blogging for a while and see how it goes.
Here is my latest endeavor. I made some cute little labels for a friend's hand knitted garments which she sells through a local craft shop.
I was able to use my Tonic Studios dies for this, it makes for a very cute little tag don't you think?
You can't really tell from the picture, but I have a strange way of doing the printing on my inkjet printer which results in a cool raised printed effect.
Unless you have a top of the range inkjet printer, the inks will run if the label becomes wet. I want to avoid this for labels and make them a bit longer lasting. I do this with embossing powder.
As my printed card is coming out the printer, I sprinkle embossing powder over the inked areas. Because the printer uses pigment ink, the embossing powder sticks to the printing. I then tip off the excess into a big plastic tray I have for the occasion and use my heat gun to heat the embossing powder as you would do normally.
This can be a bit messy and you have to be careful not to trash your printer. But it works for me anyway.
Anyone else do this?
Have a lovely day !
No comments:
Post a Comment
Hi there, I really appreciate you taking the time to share your thoughts with me. Thanks for dropping by. I enjoy reading all your comments.